Ultra Reduction Slit Bracelet (15mm, PA)
This piece is 100% hand fabricated from metal plate; cut into sections and soldered together to make the hollow three dimensional form. If sterling silver, the sheet metal is made by hand. The silver is melted and rolled out into plate.
|XS||57 mm||28 mm|
|S||63 mm||30 mm|
|M||65 mm||33 mm|
|L||68 mm||35 mm|
OPEN-TYPE BRACELETS have two key points to consider. Firstly the actual ‘size’ which is measured by using your wrist diameter as compared to the below table. You want there to be a little wiggle room so select the size that is just slightly bigger than your actual wrist measurement.
The second key point is the thickness of your wrist, this is important to be sure you can get into the opening (Column B) but that it is not too big that the bracelet will fall off. This measurement can be a bit snug, it is best to have to squeeze into the opening part of this bracelet a bit to prevent it from falling off.
The other factor to consider where on your arm you will wear this. If you are stacking multiple bracelets you would need a size up to wear higher.
This is a relatively difficult style to determine size for, we highly recommend consulting with us to get it right. You can go ahead and order the size you believe you are and send us a message, we will help be certain about it before launching production.
Don't Worry About Size
We have your back and can help you find the perfect size according to your wearing preference as well as do customizations. Above are the basic measurements of this item for reference, but please get in touch for more help!
You are safe; You can exchange your item infinitely until you find the right piece.